Drive - hydraulic

In hydraulic lifts, the main units are: hydraulic cylinder, hydraulic station, microprocessor control system.
Hydraulic drive lifts have very high operating parameters. The stop and the start of the cab is very smooth, the movement too. They are extremely quiet, even near the engine room.
Hydraulic drive lifts have very high operating parameters. The stop and the start of the cab is very smooth, the movement too. They are extremely quiet, even near the engine room.

In intensive traveler flow it is advisable to build more lifts working with common control (duplex, triplex). The advantages of hydraulic lifts are that the engine room could be located virtually anywhere (not necessarily bounded by the lift shaft). Where necessary, it is possible to build a lift without an engine room, it is replaced by the so-called "hydraulic room". Hydraulic lifts have lower operating costs, high reliability, which makes them preferred in modern construction.

In hydraulic drive, lifting capacity of the lifts and facilities can vary widely according to the needs and wishes of the client, used as small dumbwaiters as well as passenger, freight, car and wheelchair platform lifts.

All hydraulic lifts are equipped with a standard load control device, a device for automatic removal of the cab in case of power supply failure, a device for automatic leveling of the cab to the floor platform and a system for manual movement of the cab.
Based on its long experience in manufacturing lifts, Multilift selected for their partners-suppliers of hydraulic equipment, the Italian companies: GMV and Start Elevator Hydraulic.
The company uses the following controllers for microprocessor control system: KSA-16, EKM-64, EKM-65, EKM-85 of the German company RECOBA, as well as controllers of own production.